LAP-TEQClinometer
Remote Display Unit
Build in Laserpointer
The LAP-TEQ Clinometer is designed to measure the inclination of a line-array or a cluster of loudspeakers. It consists of two components: The LAP-TEQ sensor module and the LAP-TEQ display module.
The LAP-TEQ sensor module is attached to the top cabinet of the array. Its diecast aluminum enclosure is designed to meet IP65.
The LAP-TEQ display module shows the horizontal clination of the top cabinet in a range of ±40° with a resolution of 0,1° on a dot matrix LCD-display. It powers off after two minutes to save the 9V-E-block batterypower. The last metered value is stored and appears in the displays second row after the module is turned on again. This helps you to compare several arrays.
The LAP-TEQ display module is connected to the LAP-TEQ sensor module via a normal balanced NF-connection (XLR microphone cable). The sensor module is powered by the display module via this connection which can be up to 50 meters long.
Additionally a red laser pointer diode (0,9mW, 635nm) is attached to the LAP-TEQ sensor module to show the elevation angle. This will help you to aim your line array to the last row of the audience.
LAP-TEQ will be delivered in a set of one LAP-TEQ display module and two LAP-TEQ sensor modules. You can also get more LAP-TEQ sensor modules separately if you wish to supply more than two line array bumpers with sensor modules permanently.
Dimensions:
display module 125 x 61 x 37 mm, weight 240 g
sensor module 122 x 39 x 32 mm, weight 138 g
lapteq 
Download flyer |
